Mansooreh Dehghani; Mahshid Ghadami; Talat Gholami; Marzieh Ansari Shiri; Zahra Elhameyan; Mohammad Reza Javaheri; narges shamsedini; Samaneh Shahsavani
Volume 3, Issue 4 , October 2015, , Pages 139-145
Abstract
Background: Recently, there has been a great concern about the consumption of dyes because of their toxicity, mutagenicity, carcinogenicity, and persistence in the aquatic environment. Reactive dyes are widely used in textile industry. Advanced oxidation processes are one of the cost-effective methods ...
Read More
Background: Recently, there has been a great concern about the consumption of dyes because of their toxicity, mutagenicity, carcinogenicity, and persistence in the aquatic environment. Reactive dyes are widely used in textile industry. Advanced oxidation processes are one of the cost-effective methods for the removal of these dyes. The main aims of this study were determining the feasibility of using Fenton process in removing Reactive Red 198 (RR-198) dye from aqueous solution and determining the optimal conditions. Methods: This is a cross-sectional study conducted at a laboratory scale. A total of 69 samples were considered and the effect of pH, Fe (II) concentration, H2O2 concentration, initial dye concentration and reaction time were investigated. Results: According to the results, a maximum removal efficiency of 92% was obtained at pH of 3 and the reaction time of 90 min; also, the concentration of Fe (II), H2O2, initial dye concentration were 100 mg/L, 50 mg/L, and 100 mg/L, respectively. The results revealed that by increasing the concentration of Fe (II), H2O2 and initial dye, the removal efficiency was increased. Conclusions: The results showed that Fenton process could be used as a cost-effective method for removing RR-198 dye from textile wastewater efficiently.
narges shamsedini; Mohammad Ali Baghapour; Mansooreh Dehghani; Simin Nasseri
Volume 3, Issue 3 , July 2015, , Pages 94-100
Abstract
Background: Atrazine is one of the most widely used triazine herbicides which has been used for controlling broadleaf and grassy weeds for many years. Its widespread use in water has caused environmental concern because of frequent detection of atrazine in aquatic systems where this herbicide has been ...
Read More
Background: Atrazine is one of the most widely used triazine herbicides which has been used for controlling broadleaf and grassy weeds for many years. Its widespread use in water has caused environmental concern because of frequent detection of atrazine in aquatic systems where this herbicide has been spilled. Therefore, the purpose of this study was to determine the herbicide removal efficiency at the optimal conditions. Methods: The effect of different parameters including pH at three different levels (3-11), the initial concentration of atrazine at three different levels (0.1-10 mg/L), and reaction time at five different levels (0-120 min) on the removal of atrazine in the aqueous phase using ultraviolet radiation (1020 μw/cm2) was investigated. Finally, the data were analyzed using SPSS software (version 16). Results: The results demonstrated that atrazine removal rate increased by increasing pH, initial atrazine concentration, and reaction time. The maximum rate of atrazine removal (99.2%) at optimal condition occurred in pH=11, atrazine concentration=10 mg/L at 30 min. Conclusion: According to the findings, it can be concluded that the UV-A process is an effective and commodious method for reducing atrazine in polluted water resources.
